Please follow these instructions when using the MAXTRAX Mounting Pin Set:

Ensure all 4 pins are used for mounting.


Layout dimensions. Please note: Manufacturing tolerances (of +/-1%) may affect these dimensions slightly so please check these dimensions against your MAXTRAX before drilling.

MPS layout dimensions

Pins MUST be mounted vertically so that the MAXTRAX are carried horizontally.


Please note: You will need to trim 15mm off the thread for use in channel-type roof bars.

single-MP-close-up Single-pin-&-bar _DSC1519 _DSC1521

Ensure pins are aligned so that the padlock hole in the top ‘knuckle’ is visible once the MAXTRAX are locked down.


For additional security, fit a small padlock through the most easily-accessible mounting pin.

A wire combination padlock is the best option (they are readily available and you can’t lose the key!).